Share this content on Facebook!
01 Oct 2015

Are you some of those people who know merely the basics of their jeep? How to begin, brake, and accelerate? You can find much more about your jeep or other vehicle that you should know. Begin to see the two tail pipes at buttocks of your car? Those are the visible part of the exhaust system. Yes, there is a whole bigger exhaust system on the bottom. If you are wondering what holds up there, this is what this post is about. It will make you know about your exhaust clamps. - Exhaust Clamps

The Exhaust Band clamps
These are used to connect two exhaust pipes. It is a clamp designed to stretch across the two pipes and make a seal. They are available in different sizes and designs. The one that includes a block between he ends of the clamps is easy to install. You'll have to tighten the clamps until it locks around the blocks. If you are looking on the size of your pocket before buying a clamp, you might want to consider the ones with a foil between the ends of the clamps. These are cheaper and also easy to install.

For giant trucks, welding is preferable since it is stronger. It can cause holes in the exhaust system alternatively, especially if he welding isn't done right. Exhaust clamps would be the other alternative. They can hold on very well should they have been well tightened. However, with the vibration on rough roads, they can become lose and noisy. If yours is an everyday jeep, then you can use the exhaust system.

You will find clamps in aluminum and stainless steel. The best exhaust clamps are 100% stainless-steel and do not rust. They won't rust on your exhaust.

The U-Bolt Exhaust Clamp
This clamp is designed to fold the pipe when tightened to produce the seal. It isn't advisable to use the U-bolt clamps. The reason being they break when removed and are not in a good condition for re-use. The have excess thread which you can use to fasted to a bracket after tightening the clamp for extra support.

V-Band Exhaust Clamp
This clamp can be commonly known as Turbo Clamp. Inside these bands is a built -in angled grooves. The grooves blend with all the flange on the turbo housing and the flange on the exhaust pipe. There are different kinds of the V-band exhaust clamps available in different designs. All you need to check is to make sure you have the right diameter that's the size of your exhaust tubes. When the diameter is right as well as the groove width, the bands will easily fit in just fine. - Exhaust Clamps


Comments

There isn't any comment in this page yet!

Do you want to be the first commenter?


New Comment

Full Name:
E-Mail Address:
Your website (if exists):
Your Comment:
Security code: